Wood Burn with Ammonium Chloride
Here's a printable recipe for a wood burning gel that will make your next wood burning project fast and easy!
Immersion blender or Magic Bullet (dedicated to crafting)
Clear Coat spray
thickener - Thicken Up or Xanthan Gum
Cut stencil by hand or use a Cricut. Tip: use a good qualty vinyl
Apply stencil to wood and seal with several light coats of clear coat. Let dry overnight.
Mix together ammonium chloride, warm water and add 1/4 tsp of thicken up or Xanthan gum.
Tip: Blend with an immersion blender or in a Magic Bullet - just a few pulses until gel consistency.
Peel stencil and brush solution onto the bare wood. Let dry.
Set heat gun to high. Tip: Use short bursts and hold the heat gun a good distance away.
Keep the gun moving until desired effect is achieved.
Recipe Source: The Unknown Chef at Birdzofafeather.ca